Protocol
NAD+ (1000 mg Vial)
Complete dosage protocol and reconstitution guide for NAD+ (1000 mg Vial).
Calculator preset
Run the vial math before tracking.
At 100 mg/mL, 1 unit = 1 mg ; 50 mg = 50 units (0.50 mL) and 100 mg = 100 units (1.0 mL) on a U-100 syringe.
01 · At a glance
Quickstart Highlights
NAD+ (nicotinamide adenine dinucleotide) is a critical coenzyme involved in cellular energy metabolism, DNA repair, and mitochondrial function [1] . Clinical research has primarily employed intravenous infusions at high doses, though subcutaneous administration at lower doses is emerging as a practical maintenance route [2] [3] . This educational protocol presents a once‑daily subcutaneous approach with gradual titration for improved tolerability.
02 · Dosing & reconstitution
Dosing & Reconstitution Guide
A practical calculator-ready setup based on the imported protocol reference. Use these values as a math starting point, then verify every entry against your own vial, diluent, and professional guidance.
Standard / Gradual Titration Approach (3 mL = 333.3 mg/mL)
50–100 mg once daily subcutaneously (gradual titration from lower doses).
Reconstitution Steps
- Allow the lyophilized vial to reach room temperature before opening to minimize moisture condensation.
- Draw 3.0 mL bacteriostatic water (0.9% benzyl alcohol) with a sterile syringe.
- Inject slowly down the vial wall to avoid foaming; do not aim directly at the powder.
- Gently swirl or roll the vial until the powder fully dissolves (do not shake vigorously).
- The resulting solution should be clear and colorless.
03 · What you'll need
Supplies Needed
Keep this as a planning checklist. TNHL does not sell or verify supplies on this page, and no supplier quality claims are made here.
- 12 weeks ≈ 8 vials (total 7,875 mg used)
- 16 weeks ≈ 11 vials (total 10,675 mg used)
- 8 weeks: 56 syringes
- 12 weeks: 84 syringes
- 16 weeks: 112 syringes
- 8 weeks (6 vials): 18 mL → 2 × 10 mL bottles
- 12 weeks (8 vials): 24 mL → 3 × 10 mL bottles
- 16 weeks (11 vials): 33 mL → 4 × 10 mL bottles
- Per week: 14 swabs (2/day)
- 8 weeks: 112 swabs → recommend 2 × 100‑count boxes
- 12 weeks: 168 swabs → recommend 2 × 100‑count boxes
- 16 weeks: 224 swabs → recommend 3 × 100‑count boxes
Protocol Overview
- Goal: Support cellular energy metabolism, DNA repair pathways, and mitochondrial function through exogenous NAD+ supplementation [1] .
- Schedule: Daily subcutaneous injections for 8–16 weeks with gradual dose titration.
- Dose Range: 50–100 mg daily; start low (50 mg) and increase by ~25 mg weekly as tolerated.
- Reconstitution: 3.0 mL per 1000 mg vial (333.3 mg/mL) for accurate unit measurements.
- Storage: Lyophilized powder frozen at −20 °C (−4 °F); reconstituted solution refrigerated at 2–8 °C (35.6–46.4 °F) for up to 14 days; protect from light.
Dosing Protocol
- Suggested daily titration approach for subcutaneous administration.
- Start: 50 mg daily for Week 1 to assess individual tolerance.
- Escalation: Increase by 25 mg in Week 2 (75 mg daily); advance to 100 mg daily by Week 3 if well‑tolerated [4] [5] .
- Maintenance: Continue at 100 mg daily for Weeks 3–16 (or adjust based on response and tolerability).
- Frequency: Once per day, subcutaneous injection.
- Timing: Any consistent time of day; some users prefer morning administration.
- Site Rotation: Rotate injection sites systematically (abdomen, thighs, upper arms) to prevent tissue buildup.
Storage Instructions
- Lyophilized: freeze at −20 °C (−4 °F) ; after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F) for up to 14 days; protect from light and avoid freeze–thaw cycles.
- Storage: Lyophilized powder frozen at −20 °C (−4 °F); reconstituted solution refrigerated at 2–8 °C (35.6–46.4 °F) for up to 14 days; protect from light.
- Keep mixed and unmixed items clearly labeled so inventory and dose logs stay accurate.
04 · Good to know
Important Notes
- Practical considerations for consistency, safety, and optimal results.
- Use new, sterile insulin syringes for each injection; dispose of used needles in a proper sharps container.
- Rotate injection sites systematically (abdomen at least 2 inches from navel, outer thighs, back of upper arms) to reduce soreness and prevent lipohypertrophy.
- Clean both the vial stopper and injection site with alcohol swabs; allow skin to air‑dry before injecting.
- Inject slowly over 5–10 seconds to minimize tissue irritation; wait a few seconds before withdrawing the needle.
- Document daily dose, injection site, and any observed effects to maintain consistency and track tolerance.
- If persistent redness or a lump develops at injection sites, apply over‑the‑counter hydrocortisone cream and rotate to a different location.
05 · How it works
How This Works
NAD+ (nicotinamide adenine dinucleotide) is a critical coenzyme involved in cellular energy metabolism, DNA repair, and mitochondrial function [1] .
Clinical research has primarily employed intravenous infusions at high doses, though subcutaneous administration at lower doses is emerging as a practical maintenance route [2] [3] .
This educational protocol presents a once‑daily subcutaneous approach with gradual titration for improved tolerability.
The library page pairs that educational context with calculator-ready vial math, so users can understand the protocol structure and then track their own entered values in one place.
06 · Daily habits
Lifestyle Factors
- Keep meals, training, sleep, and recovery notes in the journal so trends are easier to review.
- Track body metrics only if they are relevant to the user's goal and approved data sources.
- Use consistent timing and logging habits so adherence data is meaningful.
07 · What to expect
Potential Benefits & Side Effects
- NAD+ observations should be recorded conservatively: expected research endpoints, tolerability notes, injection-site reactions when applicable, sleep, appetite, energy, mood, and any adverse or unusual response.
- This section is not a claim of therapeutic benefit.
08 · Technique
Injection Technique
- Wash hands with soap and water.
- Wipe the vial stopper and chosen site with alcohol, then let both dry.
- Confirm the vial concentration, calculator result, and intended draw amount before loading the syringe.
- Use the route and needle technique directed by a qualified professional or product instructions.
- For subcutaneous injections, rotate sites and inject slowly to limit leakage and irritation.
- Do not reuse needles or syringes.
- Dispose of sharps in a puncture-resistant container.
- Return stored items promptly to the correct temperature.
- Log dose, site, date, time, inventory change, and any observation.
09 · Evidence